Q: How do I list my practice in the Caring Industry Leader™ Directory?
A: A link is provided for you in your Gruv Button Retrofit Campaign Kit™. The link takes you to the Caring Industry Leader™ Directory Listing Page.
Q: Do Gruv Buttons™ stay attached to the receiver?
A: Yes. The Gruv Button Retrofit Kits™ and Gruv Button Retrofit Campaign Kits™ include the Gruv Button™ Adhesive. You just add a drop while attaching the Gruv Button™ to the receiver. They are always right there ready to make insertion much easier – every time your patient puts their hearing aids on.
Q: What do you mean by “ergonomically designed”?
A: Gruv Buttons™ are carefully designed with special features that accommodate the fingertips, including:
Q: Do Gruv Buttons™ help with retention?
A: Yes. Gruv Buttons™ help ensure that the receiver is sufficiently deep in the canal which, of course, contributes to improved retention.
Q: How big are Gruv Buttons™? And are there various sizes? Do they fit my particular receivers?
A: Gruv Buttons™ are just slightly larger than the back-end of the receiver on the receiver-in-the-canal (RIC) hearing aid. Three ID (inside diameters) ensure that Gruv Buttons™ fit all medium-power and low-power RIC receivers. Please check the ID Size Selection Chart to find the proper ID size for your receivers.
Q: Will Gruv Buttons™ create occlusion?
A: No, because Gruv Buttons™ are just slightly larger than the back-end of the receiver.
Q: How far do Gruv Buttons™ stick out?
A: Because Gruv Buttons™ are just slightly larger than the back-end of the receiver and help position the receiver sufficiently deep in the canal, the receiver will likely be less noticeable than it would be without Gruv Buttons™.
Q: Will Gruv Buttons™ accommodate retention tails?
A: Yes. Each Gruv Button™ features a slit along its side which enables it to wrap around and tightly hug the receiver while, at the same time, accommodate the retention tail.
Q: What are Gruv Buttons™ made of?
A: The material used to make Gruv Buttons™ is a high-grade medical silicone material that was carefully selected to provide just the right degree of softness, firmness, tackiness, durability,
effectiveness in conjunction with the Gruv Button's™ special ergonomic features, and color to best match the ear canal.
Q: My Gruv Button™Adhesive Bottle was not stored in an upright position, the adhesive set up in the nozzle and now I cannot puncture it open again with the Adhesive Bottle Puncture Pin. What do I do?
A: Use a heavy-duty scissors and snip off 1/8 to 3/32 inch from the tip of the nozzle or Dispensing Tip. Now, because the nozzle hole is larger, YOU MUST BE VERY CAREFUL to allow just one drop of the adhesive into the open-end of the Gruv Button™.